Pulling Motor 2010

Here is my Sled pulling motor for 2010, Thus far the block is bored .20 over, block is filled with block filler, balanced crank, balanced-polished-shot peened rods, arias pistons, pulling cam, gorilla girdle, 14 mm extra long main studs, fully port and polished head, Intake milled off, upgraded valves and valve springs, runner intake manifold, 13 mm AG pump,LARGE injectors, LARGE twin turbo setup, electric water injection, 3/8 rocker studs, 14mm Head bolts, fire ringed head and block, and a copper head gasket. All of this combined to make close to a 1,400 HP sled pulling motor!

Projects

injection pump and lines
injection pump and lines
turbo piping
turbo piping
Turbo Mock up
Bending injection lines
Billet tappet cover and runner intake
Runner intake
Billet front cover
14 mm extra long main studs
Crank set in block
Gapping rings
Pistons in block
main caps torqued
copper head gasket and fire rings